Avery 9860 Instrucciones de operaciones descargar pdf (Pagina 86)

Initial Smart Relay Setup Procedures

Follow these steps as listed or errors may occur.

1. Connect the printers. See “Connecting the Printers,” for more

information.

2. Turn on the partner printer.

3. Configure the Partner Printer. See “Configuring the Partner Printer

,”

for more information.

4. Turn off the partner printer.

5. Turn on the primary printer.

6. Configure the Primary Printer. See “Using the Smart Relay Telnet

Commands,” for more information.

7. Turn off both printers.

8. Turn on the primary printer. Wait until you see "Smart Relay Ready,"

then turn on the partner printer.

9. Send your data.

About the Primary Printer

The primary printer

♦ must be a 9855 printer using MonarchNet2 software

♦ can have only one partner

♦ connects to the partner printer using a serial cable. You cannot use

the optional external keyboard with the primary printer.

Note: There is no bi-directional communication between the primary

and partner printers.

For maximum efficiency, the primary printer should print the majority of

the supplies. If you print more RFID supplies than non-RFID supplies,

make the RFID printer the primary printer. This reduces the amount of

data transferred to the partner printer and requires less processing by

the primary printer.

5-2 MonarchNet2 Operating Instructions

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 113 114

Sin comentarios

Avery 9860 Instrucciones de operaciones Pagina 86